20 TON POLE TRUCK:
Tulsa 80, fabricated with complete dog and brake. Air controls to be installed in customer's truck cab. To be installed with air controls for forward and reverse operations.
Tulsa 34, air controlled brake. Air operated controls for forward and reverse operations, cutomer supplies cable tail chain and hook. Operated by a 6-hole two direction PTO, driveshaft will be slip yoke and 1550 Series shafting, double 80 chain and sprockets, heavy pillar blocks and shafts.
Power Take Offs:
Unit outfitted with 8-Hole and 6-Hole PTO's and controls.
Gin Poles :
Standard Solid 20 ton gin poles, the main barrels to be 5 1/2" in diameter and the inserts to be 4 1/2 and 3 1/2" coupled together with Machine drilled holes on 24" centers. Comes with Hootenanny block, crown pin and all necessary components including pole knuckles etc
Holland 5th Wheel Plate w/6" Pedestal legs.
Applicable wheel base, bed to fit heavy-duty fabrication design. Bed to be fabricated out of 1/2 ” carbon steel plate with all supports. Bed to have strap down bed frame. Cross members will be 4” –13# with beam. Rear butt plate to be fabricated from 1” plate with 4” pipe outer design. Poll risers fabricated with 2” cold shaft and 32” arms. Outside of bed to be reinforced with 8” flat bar rounded at the front. Frame to have 1/2" plate full frame to have way under cab for added frame support.
Tail Board Roller:
6” roller fabricated from Sch 120 with lube inserts to the outer part of the bed. To be supported with four 3” support rollers.
Headache rack to be four-post chain type rack, design in position to accommodate poles, with racks to be fabricated on each side, made from 4" pipe with all radiuses made with 90°. Welded Ells.
Front Bumper: Oilfield bumper fabricated from 6" pipe. Each side will have fender locators. Lower protection bolt on skid plate.
Two installed 18" X 18" X 36" gasket sealed door with locking key mechanism.
Tank Guards: Two tank Guards to be fabricated on each side to provide additional protection against elements for Fuel Tank.
Lights: Unit will have LED DOT approved lights, Amber/Red Marker lights on side of unit, three Red clearance Lights at top rear of tank, two rear turn/brake tail lights 4.5' red, two rear back up lights 4.5" and one license plate light assembly with sealed harness application.
Mud Flaps: DOT WDF Tornado Anti-Sail Mud flaps Left / Right Rear Bumper.
Water Cooler: 5 Gal Water Cooler and Rack installed on Driver's Side.
Tire Rack: Spare Tire Carrier Rack installed on passenger's side, underneath.
Back Up Alarm: Back up alarm to be mounted on truck frame at rear, wired to reverse switch application.
Paint: Exterior Coated High Build Epoxy Primer and Customer's One color Black coated with High Solids Polyurethane, 4-6 MIL Dry film thickness, Multi-Colors to be an additional amount, as well as decals and lettering to be additional.
Rear Work Lights: Two work lights mounted on left and right on light bar at top rear of tank that is wired in harness to a toggle switch in truck for operation.
Beacon Light: Yellow Strobe Beacon Light Mounted/Wired into Harness.
Installation: Unit mounted on customer's truck. Any modifications to truck would be wheelbase not applicable.